Drywall Repair Kent logo
Square drywall patch with fresh joint compound on a living room wall, a taping knife and mud pan beside it and a drop cloth on the floor

Free drywall referral line for Kent, WA

Ceiling Drywall Repair in Kent, WA

  • Typical cost: HomeGuide puts minor ceiling repairs (holes, cracks) at $200 to $500, and bigger jobs such as a sagging section or a replaced ceiling at $400 to $1,200.
  • Time on the job: 1 to 3 hours for a small ceiling repair; 1 to 3 days to replace a drywall ceiling, per the same guide.
  • Sagging ceilings: $2 to $4 per square foot to redo the drywall, with a $250 to $500 minimum.
  • Board rule: a ceiling that will get a water-based texture needs at least 1/2-inch board on 16-inch framing and 5/8-inch on 24-inch framing.

Drywall Repair Kent will put your photos in front of an independent drywall contractor for the sagging bedroom ceiling or the hole the old light fixture left. A wide shot of the room and a close-up of the damage are enough to start. If the ceiling is stained or soft from a leak, the ceiling water damage page is the better fit.

Ceiling Repairs That Aren't From a Leak

Everything on this page assumes the ceiling is dry and the cause is wear, movement or an old fixture, not water.

Bedroom drywall ceiling sagging between two joists with screw heads pulling through the paper

Sagging Panels Pulling Away From the Joists

HomeGuide calls this "pillowed" drywall and gives four causes: termites, structural damage, water, or 1/2-inch board hung under joists or trusses set 24 inches apart. Its description of the proper repair is to take down the sagging board, hang thicker 5/8-inch sag-resistant board and repair the attic insulation above it.

  • Drywall: $2 to $4 per square foot, $250 to $500 minimum. That is HomeGuide's rate for taking down and rehanging the board, the same as its price for a new drywall ceiling, not a per-square-foot patching rate
  • Lath and plaster ceilings: priced on a different scale, with repair running far higher per square foot than a full replaster; HomeGuide's figures are on the plaster and lath repair page.
  • A drywood termite inspection runs $0 to $250, since termites are one cause of buckling

Openings Left by Moved Lights, Fans and Vents

Moving a fixture leaves a hole of a known size, which makes these the easiest ceiling repairs to price from a photo. HomeGuide's ceiling-hole figures:

  • Under 1 square foot: $50 to $150
  • 1 to 2 square feet: $100 to $300
  • 2 to 4 square feet: $200 to $500
  • Each added hole on the same visit: $150 to $350, about 25% less than the first

If a fixture has to come down and go back up, an electrician is a separate bill; HomeGuide lists $50 to $130 an hour plus a $100 to $200 call-out fee.

Cracks Across the Room or at the Wall Line

A crack where the ceiling meets the wall usually opens and closes with the seasons, which HomeGuide puts down to truss uplift. Cracks across the middle of a room or in a bowed ceiling are a different matter. Both are covered, with the warning signs, on the drywall crack repair page.

Dents and Punctures, Including Garage Ceilings

A dent or puncture under 1 square foot sits in the smallest price band above. One thing to mention when you send the request: if the damaged ceiling is in a garage with bedrooms or living space above it, that ceiling is a fire separation with its own board rule.

New wood furring strips screwed across an old ceiling before a fresh layer of drywall

Re-Covering a Tired Ceiling With New Board

When a ceiling has been patched many times or sags in several places, covering it can make more sense than repairing it. HomeGuide describes furring strips or spacers fastened to the joists with new 5/8-inch board hung below the old ceiling. It's quicker and cheaper than tearing out, and the trade-off is a slightly lower ceiling. HomeGuide puts a new drywall ceiling, installed, at $2 to $4 per square foot. That is a replacement price; patching runs far higher per square foot (HomeAdvisor puts drywall ceiling repair at $45 to $55 per square foot including labor).

Basement walls with taped and mudded drywall seams, a pole sander, a compound bucket and a work light

Why Kent homeowners, landlords and businesses call Drywall Repair Kent

  • Your request goes to one independent local drywall contractor, not a bidding list
  • The referral is free, and booking is up to you
  • Ask for the finish level, texture and paint as separate lines
  • Check L&I registration and bond before work starts
  • Keep the deposit small and pay as the coats are finished

Get a free drywall repair estimate

Free for homeowners, landlords and businesses. One local contractor contacts you.

Ceiling Board Thickness and Screw Spacing

Washington adopts the 2021 International Residential Code with state amendments, and the amendments leave the drywall fastening section, R702.3, as written. For ceilings that means:

  • Fasteners on 1/2-inch or 5/8-inch ceiling board

    nails no more than 7 inches apart, screws no more than 12 inches apart (walls allow 8-inch nails and 12- to 16-inch screws)
  • Screws

    Type W or Type S, reaching at least 5/8 inch into the wood framing
  • Textured ceilings

    where a water-based texture will be sprayed or troweled on, board runs across the framing, 3/8-inch board isn't allowed, and the minimum is 1/2 inch at 16-inch spacing or 5/8 inch at 24-inch spacing
  • Wet locations

    interior gypsum board may not go where it's directly exposed to weather or water

The textured-ceiling rule is the one to remember when you look at a sagging ceiling: the sag cause HomeGuide names, 1/2-inch board on framing 24 inches apart, falls below the code minimum whenever that ceiling carries a water-based texture. Ask what thickness the new board will be and how it will be fastened. Board types for other rooms are on the drywall installation page.

What a Ceiling Repair Costs

HomeGuide's average for drywall or plaster ceiling repair is $300 to $1,200, with a $700 national average. That page says most contractors charge a $125 to $200 minimum for ceiling repairs, so a single small hole often costs the minimum and a second hole on the same visit costs less. Small ceiling repairs with retexturing run $50 to $100 per square foot; painting and texturing on their own add $150 to $600. Guides differ on minimums: HomeGuide's general drywall repair page puts most contractors' minimum job fee at $350 to $650 or more, which is the figure in the cost section on our homepage.

These figures come from national surveys of past jobs, not from anyone who has climbed a ladder in your house. Use them to judge whether a written quote is in a sensible range, and ask for patching, texture and paint to be priced as separate lines so you can see where the money goes.

Ready to get started in Kent?

Tell us about the job and a local drywall repair contractor will get back to you with a free estimate.

Get a free drywall repair estimate

Free for homeowners, landlords and businesses. One local contractor contacts you.