Drywall Repair Kent logo
Square drywall patch with fresh joint compound on a living room wall, a taping knife and mud pan beside it and a drop cloth on the floor

Free drywall referral line for Kent, WA

Drywall Repair After Plumbing and Repipes in Kent, WA

  • Patching after a repipe: HomeGuide adds $300 to $1,500 or more to a whole-house repipe for closing up the drywall the plumbers opened.
  • Time on the wall: the patch itself is quick; the wait is drying, at 12 hours or more per coat of compound (HomeGuide), which usually spreads one access hole over a couple of visits.
  • A leak found behind the wall: HomeGuide's range for that pipe repair is $500 to $5,000+.
  • Kent permit line: the city's minor plumbing permit covers fixtures replaced in place "without removal of any surfaces such as gypsum."

Drywall Repair Kent opens a line to an independent drywall contractor for the openings your plumber, electrician or tile setter left in the wall. Photograph each hole with a tape measure in the shot, note whether the wall has texture, and ask for a price on closing each one.

Openings Other Trades Leave Behind

Each of these starts with someone else's work: a leak hunt, a repipe, a new circuit, a tile tear-out. The drywall side is the same in all of them (back the hole, fill it, tape it, feather it, blend it), but what's behind the board decides when it can start.

Square access hole cut low in a hallway wall, exposing a copper pipe and studs

Access Holes Cut to Find a Leak

A plumber chasing a leak cuts where the stain or the drip points, and the first hole isn't always the last. HomeGuide notes that a leak behind a wall usually means cutting into drywall and opening the wall to reach the pipe. Before a patch goes on, the cavity has to dry out. EPA's 24 to 48 hour window and what to do with board that stayed wet are on the water-damaged drywall page.

  • If the plumber hasn't cut yet, ask for square, straight cuts rather than a ragged opening.
  • Leave the opening uncovered until the plumber confirms the repair holds under pressure.

Repipe Openings, Room by Room

A repipe leaves a trail: under sinks, behind the tub wall, along ceilings where lines cross. HomeGuide notes that PEX can often be snaked behind drywall, which cuts the number of openings, and prices patching the rest at $300 to $1,500 or more on top of the repipe itself. Walk the house with the plumber and count them before you ask for a drywall price.

  • Note which rooms have texture or paint you want matched; blending is priced on the texture matching page.
  • Ceiling openings take longer than wall ones because every coat goes on overhead.

New Circuit and Outlet Cut-Ins

HomeGuide points out that electricians cut holes in drywall for repairs and upgrades: a slot beside a box, a strip along the wall to fish a new run. These are small, but there are often several in one room. In a wall between an attached garage and the house, the patch also has to keep the fire separation intact; the garage firewall page covers what that wall needs.

Damage Left by Tile or Backsplash Removal

What comes away with the tile decides the drywall fix. HomeGuide puts removing a 20 to 40 square foot kitchen backsplash at $40 to $280 and stripping bathroom wall tile at $210 to $1,900, and neither figure includes the wall underneath. Torn face paper gets sealed and skimmed (the wallpaper removal page walks through it); gouged or soft board gets replaced. If new tile is going back up inside a tub or shower, the code calls for a listed tile backer there, not plain drywall (board types).

Access Panels Where a Valve Needs Reaching

Some openings shouldn't be closed solid. A shower valve, a tub pump or a drain cleanout behind a closet wall is easier to service through a framed access panel than through a fresh cut every few years. The panel goes in during the patch, so decide before the drywall visit.

Basement walls with taped and mudded drywall seams, a pole sander, a compound bucket and a work light

Why Kent homeowners, landlords and businesses call Drywall Repair Kent

  • Your request goes to one independent local drywall contractor, not a bidding list
  • The referral is free, and booking is up to you
  • Ask for the finish level, texture and paint as separate lines
  • Check L&I registration and bond before work starts
  • Keep the deposit small and pay as the coats are finished

Get a free drywall repair estimate

Free for homeowners, landlords and businesses. One local contractor contacts you.

Plumber, Electrician or Drywall Contractor: Who Closes the Wall

The drywall contractor, in most cases, once the other trade is finished. HomeGuide's plumbing guide treats drywall as a separate line after the leak is fixed, with new board at $1.50 to $3.50 per square foot installed. Repipe and leak quotes often stop at the cut.

The Kent permit question sits with the plumbing work, not the patch. Kent's minor plumbing permit is written for "removing or replacing plumbing or fixtures in the same location without removal of any surfaces such as gypsum, framing, etc." Our reading: once a job opens the wall to reach pipe, it is past that minor permit. The Kent Permit Center (253-856-5300) gives the final answer. Kent says it typically processes minor residential permits, plumbing included, in 2 to 3 business days.

Before the drywall visit, have these ready:

  • Which permit the plumber pulled, and whether an inspection is still due before the wall is closed
  • A photo of each opening with a tape measure in the frame
  • Whether the plumber or the drywall contractor hauls away the cut pieces

For who may patch drywall for pay in Washington and how to check a registration, see the patching and hole repair page. The new installation page covers Kent permits for new walls and basements.

Frequently asked questions

The plumber cut three holes in our hallway looking for a leak. Can those be patched, or does the whole sheet come out?

They can usually be patched if the board around them is firm and dry. Holes a few inches apart are often squared into one opening and filled with a single piece. HomeGuide's leak-repair page lists drywall repair at $50 to $100 per square foot. Board that is soft or stained past the cut is a water-damage job instead.

Our repipe quote says the drywall is by others. What should the patching quote list?

It should list the number of openings, the rooms, and whether texture, primer and paint are included. HomeGuide adds $300 to $1,500 or more for closing a repipe. Ask for ceiling openings to be priced on their own line.

We're getting a new shower valve. Should the wall behind it get an access panel instead of a patch?

If the back of that wall is in a closet or hallway, a panel is worth considering. It lets the next plumber reach the valve without cutting the wall again. Ask whether the panel will be a paintable flush door or a plastic snap-in frame, and make sure it lands between studs.

Ready to get started in Kent?

Tell us about the job and a local drywall repair contractor will get back to you with a free estimate.

Get a free drywall repair estimate

Free for homeowners, landlords and businesses. One local contractor contacts you.